Bypass Transactions

Bypass Transactions are transactions done either when the system switch is in bypass mode or there is pulse signal detected without the app being used. If you are seeing bypass transactions on the website, check for the following items at your location:

• Confirm all switch positions are in the Normal On Position.
• Confirm the pulser wires are twisted pair shielded wire and in separate conduit than the electrical wires. For more information on Pulser best practices see our help article: Pulser Troubleshooting

• There may be an issue with your system installation where the pump can be authorized without using the Fill-Rite FMS app. Contact your installer to verify the system is properly wired.

  

Bypass Transaction Alerts

Bypass alerts are sent when the Fill-Rite FMS system detects fuel movement without App authorization. This can occur if the system is in bypass mode. If they are low-volume bypass transactions, it is likely the pulser is detecting electrical noise or fuel movement in the hose after the transaction.

Bypass Switch Position Alerts

The NXFM100 will send bypass alerts when the metal bypass switch is changed on the circuit board. The NXFM150 does not share this same logic. If the NXFM150 is in bypass mode, you will receive transaction alerts for volume but not switch position.

Managing Your Alerts (Notifications)

To edit your hardware alerts, go to: Settings > My Account > Notifications

Hardware Alerts is the alert type that creates bypass alerts. Each user can manage their alerts in this section of the website.